503 valid RCPT command must precede DATA or 550-Verification failed...

When sending email, you receive an immediate bounce such as the following:

Subject: RE: XXXXXX - October 27, 2009
Sent: 10/31/2009 12:40 PM
The following recipient(s) could not be reached:
'John Doe' on 10/31/2005 12:40 PM
503 valid RCPT command must precede DATA

OR

550-Verification failed for <yourname@yourdomain.com.au>
550-Unrouteable address
550 Sender verify failed

This means you must check your email before trying to send mail meaning that our mail server requires authentication, which can be achieved using one of these methods:

A) Pop before smtp -- check your email for new mail before trying to send email. This adds your IP address to a relayhosts file and allows any email to be sent from that IP address for up to 30 minutes. After 30 minutes you have to authenticate again.

B) Configure your email client to authenticate automatically by checking the "my server requires authentication" box in your email configuration. You will be able to send mail without having to "pop" your mail box first.

If using MS Outlook, please try the following:

1) Open outlook
2) Go to Tools/Email Accounts
3) Select the Account with the trouble and click Change
4) Click on More Settings
5) Click on Outgoing Server Tab
6) Click "Outgoing Mail Server (SMTP) requires authentication" and make sure "Use same settings as incoming mail server" is selected (see below image)
7) Click on "Advanced Tab"
8) Set outgoing Port (SMTP) to 587
9) Click Ok and then Test Account Settings

If it fails on send then repeat starting from 7.

7) Click on Advanced Tab
8) Set outgoing Port (SMTP) to 587 or 465
9) Check the box Beside "The server requires an encrypted connection (SSL)".
10 ) Click ok and then Test Account Settings

  • 15 Users Found This Useful
Was this answer helpful?

Related Articles

How do I create an email account?

To create an email account log in to your control panel (http://www.yourdomain.com/cpanel/) and...

How do I Access and use webmail?

You can access your webmail by going to http://www.yourdomain.com/webmail or by going into your...

Is there a mailbox storage limit?

You can define the mailbox storage quota on any mail account via the webmail interface or the...

My e-mail is going to the bulk or spam folder!

All domains that are created on our servers are monitored VERY closely for spam to prevent any...

Why can't I log into my cpanel or webmail?

The control panel runs on port 2082 so if you are behind a firewall or proxy server you might...